Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PIX501 to Netopia R910 IPSec

I am trying to create a tunnel between the above two devices. The tunnel is not coming up and I ran a debug to help me figure it out. However, the debug doesn't really show any errors. On the Netopia side all I get is "Phase 1 Complete" and nothing else. PIX debug and config is attached.

Anybody have any ideas?

Thanks in advance.

Diego

1 REPLY

Re: PIX501 to Netopia R910 IPSec

Hi, please check that ipsec parameters match the other side, especially the crypto acl.

Do you have any other debugging from the Netopia?

130
Views
0
Helpful
1
Replies