03-04-2002 07:25 PM - edited 03-08-2019 09:58 PM
Hi,
I need help in setting up the pcanywhere connection from remote site through pix515. I set up static nat, access rule tcp: from any to any, udp: from any to any. did not work. change to tcp: from any to pcanywhere-data, udp: from any to pcanywhere-status. did not work either. change to ip: any. no luck. I'll appreciate any help.
Thanks.
03-05-2002 12:45 PM
Pcanywhere uses TCP on port 5631 and UDP on port 5632. After you have configured your static then create your access list as follows on your outside interface:
access-list acl_outside permit tcp any host xxx.xxx.xxx.xxx eq 5631
access-list acl_outside permit udp any host xxx.xxx.xxx.xxx eq 5632
access-group acl_outside in interface outside
Remember, to do a clear xlate after modifying your static command.
03-06-2002 04:45 AM
thank you very much, that worked.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: