Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

pix515 and X session

Hi,

I need to open a session X between an inside interfaceand the dmz. I put a acl by opening the port xdmcp inside towards dmz but how to make for dmz towards inside and ports 6000 and 6063?

thanks

3 REPLIES
Community Member

Re: pix515 and X session

Inside will have access to DMZ if no ACL are in place, DMZ will have a path back to the inside interface as it has a TCP state open.

If you are using ACLs to control inside outbound traffic you will have to enable a return ACL on the DMZ interface.

Community Member

Re: pix515 and X session

I am using ACLs to control the traffic, I put this one

access-list inside-int permit udp host X.Y.Z.0 host A.B.C.D eq 177

but I can't define the return ACL

access-list dmz-int permit tcp host A.B.C.D host X.Y.Z.W eq ?????

Community Member

Re: pix515 and X session

the access-list only effect the income traffic to the pix

95
Views
0
Helpful
3
Replies
CreatePlease to create content