Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

PIX515 - Change of static NAT not taking effect until reboot?

Hi,

Customer has removed a static NAT entry and replaced it with a new one - uses the same original destination but a new NAT'd destination.

"clear xlate" removes the old entry from the xlate table, but as soon as anyone attempts to access the host, the OLD NAT destination comes back again, rather than the newly configured static.

Does anyone have any idea of why this may occur? A reboot resolved the problem, but this is less the satisfactory.

6.31, btw.

Cheers,

Mike.

1 REPLY
New Member

Re: PIX515 - Change of static NAT not taking effect until reboot

6.31 .. First guess would be code - I have not upgraded a lot of Firewalls to 6.31 as of yet so I have not seen it. I would do some testing and if you can reproduce open a case with TAC.

Regards,

103
Views
0
Helpful
1
Replies
CreatePlease to create content