Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

PIX515 no console access

I have a pix 515 that was upgraded to 6.3(5) and pdm3.04.

The device works fine for one day and then stops working. The power supply is on, the Ethernet interfaces give link but there is not response and no console access also, during boot process there is nothing on the console.

Would the upgrade creates a problem or it was just bad luck on the hardware?

Thanks.

  • Other Security Subjects
1 REPLY
New Member

Re: PIX515 no console access

Hello,

Are you getting the initial boot screen when the PIX boots?

I had a similar problem after upgrading, i forget to which version. My problem was the CMOS battery, evrything looked to be working but nothing was.

If you take the battery out, clean and replace it will usually start. If it does get a new battery as it won't last for long.

HTH.

Andy.

105
Views
0
Helpful
1
Replies
This widget could not be displayed.