Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PIX515E Interface Problem?

I have a PIX515E, I have installed 2 PIX-1FE cards in the two slots, but only one PIX-1FE is working not the 2nd one means total 3 FE. Here is the output of show ver command.

Cisco PIX Firewall Version 6.3(4)

Cisco PIX Device Manager Version 3.0(2)

Compiled on Fri 02-Jul-04 00:07 by morlee

xxxxxxx up 4 hours 24 mins

Hardware: PIX-515E, 64 MB RAM, CPU Pentium II 433 MHz

Flash E28F128J3 @ 0x300, 16MB

BIOS Flash AM29F400B @ 0xfffd8000, 32KB

0: ethernet0: address is 0014.69e9.5731, irq 10

1: ethernet1: address is 0014.69e9.5732, irq 11

2: ethernet2: address is 000e.0ca2.8502, irq 5

Licensed Features:

Failover: Disabled

VPN-DES: Enabled

VPN-3DES-AES: Disabled

Maximum Physical Interfaces: 3

Maximum Interfaces: 5

Cut-through Proxy: Enabled

Guards: Enabled

URL-filtering: Enabled

Inside Hosts: Unlimited

Throughput: Unlimited

IKE peers: Unlimited

This PIX has a Restricted (R) license.

So kindly tell me to use the 2nd PIX-1FE in 2nd slot, May I have to upgrade the IOS version or only one PCI card is supported at a time.

1 REPLY
Gold

Re: PIX515E Interface Problem?

With restricted licence you can have max three 10/100 interfaces.... So you need upgrade to unrestricted if you want to use 4 interfaces

M.

Hope that helps, rate if it does

93
Views
10
Helpful
1
Replies