Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

pix525 - stops passing traffic from certain ip's

we have two 525's in a failover mode. We have seen an issue a few times where a certain user is unable to connect to the internet. If we reload the pix and it failsover to the other it starts working again. any ideas?

1 REPLY
Silver

Re: pix525 - stops passing traffic from certain ip's

Always enter configuration changes on the Active unit. Configuration changes entered on the Standby unit are not saved to the Active unit. Only use the default configuration initially to ensure both units are working correctly.

http://www.cisco.com/warp/public/110/failover.html

94
Views
0
Helpful
1
Replies
CreatePlease to create content