Some Cisco Technical Samples have mentioned the command "nat (inside) 0 access-list " ,i have used it on a PIX525 but it didn't function and the comand i typed didn't appear in the output of "show conf" command.
Re: PIX525 with "nat (inside) 0 access-list" command
Did you save the config before doing a "show conf". Try the command "write term". Show config lists the start-up configuration of the pix and not the running config. Write term will list the running config.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...