Pix5x <-> Pix6x tunnel exists; no traffic goes through
We've set up several (ok, more than 1, less than 10) Pix tunnels V5x to V5x. Now the new PIXs have V6x on them. When we config the V6x PIX the same as we have in the past with V5x, the tunnel establishes, but no traffic goes through -- tested most with pings -- and yes we have an access-list allowing icmp -- on both systems and the debugs still say it's being denied.
Does anyone know if
- the V5x VPN is compatible with the V6x?
- there's some special config piece we need to do to get it to work?
Re: Pix5x <-> Pix6x tunnel exists; no traffic goes through
Often times complex troubleshooting issues are best addressed in an interactive trouble-shooting session with one of our trained technical assistance engineers. While other forum users may be able to help, its often difficult to do so for this type of issue.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...