11-07-2006 12:26 AM - edited 03-09-2019 04:47 PM
Hi,
I have running a pixfirewall 515 vers. 6.3(3). Time to time i am experiencing that my firerwall is blocking traffic and i can either ping or telnet to it. I am logging with trap informational level to a syslog server. How can I found out, what was hapning at the given time?
Tanks in advance.
11-07-2006 02:31 AM
Hi.
What you can do is try using capture command to filter out exact traffic. Make an access list with predefined source and destination. Use this access list in the capture statement which will show you exactly what is happening.
e.g
access-list test permit ip host a.b.c.d host k.l.m.n
capture abc access-list test in interface
logging on
11-07-2006 05:45 AM
I have same problem with PIX 506E.
I tried following one by one.
1. Firewall Config
2. Capture Access-list or interface.
3. Monitor the ports for input output queues.
But none of this wor
So finally have to replace my PIX with the new one..
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide