Hi. I have a client with a failover 5520 pair. Two DMZs. The client wants to see "some" DMZ servers using the servers' PUBLIC IP addresses "as well as" the DMZ addresses. Is this even possible? If not, it it possible to see some via their translated public IPs and others with the local DMZ addresses? Confused....
It's quite possible to have DMZ ip addresses connected to by the 'inside' and have those same servers also connected to by the internet on their public IP addresses (assuming your DMZ is privately addressed and NAT is set up from outside-->dmz)
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
[toc:faq]Introduction:This document describes details on how NAT-T
works.Background:ESP encrypts all critical information, encapsulating
the entire inner TCP/UDP datagram within an ESP header. ESP is an IP
protocol in the same sense that TCP and UDP are I...