Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

port channel asa

Hi!

Is it possible to configure etherchannel on Cisco ASA 5580 (ASA5580-4GE-CU card) ?

Thanks for your help,

 

2 REPLIES

Hi ,  Yes its supports

Hi , 

 Yes its supports etherchannel , traffic among your port-channel will be as below 

http://www.cisco.com/c/en/us/td/docs/security/asa/asa84/configuration/guide/asa_84_cli_config/interface_start.html

 

Table 12-2 Load Distribution per Interface 

# of Active Interfaces
% Distribution Per Interface
1
2
3
4
5
6
7
8

1

100%

2

50%

50%

3

37.5%

37.5%

25%

4

25%

25%

25%

25%

5

25%

25%

25%

12.5%

12.5%

6

25%

25%

12.5%

12.5%

12.5%

12.5%

7

25%

12.5%

12.5%

12.5%

12.5%

12.5%

12.5%

8

12.5%

12.5%

12.5%

12.5%

12.5%

12.5%

12.5%

12.5%

 

 

HTH

Sandy

Community Member

Yes for the 8.4 asa version

Yes for the 8.4 asa version but what about the 9 version ?

  • EtherChannel configuration on the 4GE SSM disallowed—Interfaces on the 4GE SSM, including the built-in module on the ASA 5550 (GigabitEthernet 1/ x ), are not supported as members of EtherChannels. However, although not supported, configuration was not disallowed until 9.0(1). If you configured any 4GE SSM interfaces as EtherChannel members, then upgrading to 9.0(1) or later will remove the channel-group membership configuration from those interfaces. You must alter your interface configuration to comply with supported interface types. (CSCtq62715)

http://www.cisco.com/c/en/us/td/docs/security/asa/asa90/release/notes/asarn90.html

http://www.cisco.com/c/en/us/td/docs/security/asa/asa91/release/notes/asarn91.html

 

 

66
Views
0
Helpful
2
Replies
CreatePlease to create content