Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

port redirection to an IP.

Hi guys,

will PIX gurus to tell me if it is possible to have a particular traffic from my inside network going to a particular port (maybe http) redirected to a particular IP and port.

e.g

inside to outside (destination any IP port 80 redirect to destination y.y.y.y port 8080)

y.y.y.y will be a particular IP.

thanks guys

3 REPLIES
New Member

Re: port redirection to an IP.

What version of PIX code are you using? If its 7.x, then you could use policy NAT to do the redirection.

Silver

Re: port redirection to an IP.

Policy NAT was added to code 6.2. However this does not resolve this issue. Policy Nat changes the Source address and/or port based on the destination address. It does not change the destination address or port.

Re: port redirection to an IP.

Hi .. don't think port forwarding will work for you on this scenario .. You could try alias command ..

First of all make sure your internal devices can go out to teh Internet then try ..

alias (inside) 255.255.255.255

where inside IP is the address as seen by teh inside hosts

outside Ip is the pulic IP of the server you want hte packet to be redirected to.

I hope it helps ... please rate it if does !!!

111
Views
0
Helpful
3
Replies
CreatePlease login to create content