Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Port Security on cat6500

i configure port security mac-address sticky on a cat6500, but i cann hit the global command " clear port-security sticky interface nr access"

Thanks for any response

Alain

1 REPLY

Re: Port Security on cat6500

Alain,

The clear port-security sticky is available only on the "smaller" platforms (2940, 2950, 2955, 2960, 2970, 3550, 3560, 3750, but not on the higer end platforms, such as the Cat4500 and Cat6500.

The reason not to include this command was "clear" command is to be used for dynamic addresses only. Any configured addresses should be cleared via the [no] form of the corresponding commands."

Regards,

~JG

Do rate helpful posts

105
Views
0
Helpful
1
Replies