I will be making some changes to the way our ASA 5505 is configured over the next few weeks. It is used mainly for our phone VPN clients to connect to our internal CME. The issue is that I shall be changing the inside network to another vlan and another IP address, although the name will be staying the same. I know that this will remove all the config which uses that interface name, such as NAT translations etc but my main concern is that when I put them back in again with the same name it may confuse the ASA in some way and just not work.
Has anyone had any experience with this as I would really like to know possible issues before I get to them.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...