Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

possible pix interface error

interface on standby pix shows in 'testing' state from primary. but shows as normal when logged in from standby pix. what is the problem and what can I do to correct it?

2 REPLIES
New Member

Re: possible pix interface error

actual message displayed below:

message.

--Removed post per user request (mbgoodman)--

New Member

Re: possible pix interface error

Regardless of the failover state on the primary (showing Normal) replace the cable (known good). Check your IP addressing on that interface and make sure they are on the same subnet. Check your PIX code versions to make sure they are identical (and current). Check your hardware to make sure they are identical (Failover is only supported on like models with identical hardware configurations). Just some things to try before calling Cisco.

90
Views
0
Helpful
2
Replies
CreatePlease login to create content