I have done the scenario of IOS as PPTP server. Now I want to do accounting the user traffic. I use the statment "aaa accounting network default start-stop group radius", and the Win2K IAS can receive the accounting information with packet and username.
Now I want to see the dial-in user's source ip , I mean where he comes from. How can I see this information, and which configuration is required.
This is usually because the router doesn't know the IP address until the connection fully completes. There's a hidden command called "aaa accounting delay-start" that delays the accounting record just enough so that it can include some extra info. It's not available in all IOS release levels, but anything greater than 12.0 should have it.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...