pptp connection

ysyong · ‎12-08-2005

Dear all,

I have one unit cisco 2610 , i need to form pptp with windows 2k , what i need to use commnd vpdn-group xxxx , please give an advise whick IOS can site to my router DRAM 32M and flash have 16M, thank you .

spremkumar · ‎12-09-2005

Hi

hope this link helps u out...

http://www.cisco.com/en/US/tech/tk827/tk369/technologies_configuration_example09186a00801e51e2.shtml

for the support in ur current ios code keyin the commands related to the vpdn configs and check.

if its not working out then u need to check out the exact ios code which can fit into ur box with ur current hardware resources..

u need to check this tool for getting the reqd ios to run pptp..

http://tools.cisco.com/Support/Fusion/FusionHome.do

regds

ysyong · ‎12-11-2005

Hi,

what is the feature name call ? for this vpdn configs , i try to use c2600-is56i-mz.120-28d.bin , no such command for vpdn , give an advise on IOS for my hardware c2600 , please help me , thank you

my hardware ver as below

sh ver

Cisco Internetwork Operating System Software

IOS (tm) C2600 Software (C2600-IO3-M), Version 12.2(7a), RELEASE SOFTWARE (fc2)

Compiled Thu 21-Feb-02 03:13 by pwade

Image text-base: 0x80008088, data-base: 0x809E77E8

ROM: System Bootstrap, Version 11.3(2)XA4, RELEASE SOFTWARE (fc1)

Router uptime is 1 minute

System returned to ROM by power-on

System image file is "flash:c2600-io3-mz.122-7a.bin"

cisco 2610 (MPC860) processor (revision 0x203) with 28672K/4096K bytes of memory.

Processor board ID JAD05310L7A (371552987)

M860 processor: part number 0, mask 49

Bridging software.

X.25 software, Version 3.0.0.

Basic Rate ISDN software, Version 1.1.

1 Ethernet/IEEE 802.3 interface(s)

1 Serial network interface(s)

1 ISDN Basic Rate interface(s)

32K bytes of non-volatile configuration memory.

16384K bytes of processor board System flash (Read/Write)

Configuration register is 0x2102

Richard Burts · ‎12-11-2005

I have not found a feature set with the features that you need that will run in 32 MB of memory. I found one realease in 12.1 code that only required 40MB. But most are like this one c2600-ik9s-mz.122-23f.bin which was the first version in the 12.2 releases to attain GD status and they require 48 MB of memory.

HTH

Rick

HTH

Rick