vpdn group 1 client configuration address local mypool
vpdn group 1 ppp authentication mschap
vpdn group 1 client authentication local
vpdn group 1 ppp encryption mppe 128 required
vpdn enable outside
After that I did connection to our PIX 501 and I successfully connected and obtained IP address. I didnt configure ACL. We have one server translated with static. But problem is that I cannot connect to this server throught VPN.
After that I have configured explicit ACL but output is the same.
Perhaps the traffic is getting to your server, but your server is not sending it back.
You might want to do some network sniffing to see where the traffic actually stops.
One other thing you can try; do a "show access-list" on your pix, and look at the hitcount of your nat0 access-list. If it doesn't increment, it is most likely that the traffic never gets out of your network.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...