Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Preconfigure Cisco VPN Client 5.0.00.0340 do not work

Hello,

I have an end customer who prepare some Preconfiguration CISCO VPN client for end user in version 5.0.00.0340.

He used the MSI to creat the install files to send it to the user.

Whith the old version of the CISCO VPN client, the parameter are all save when the User install it. But whith the new version 5.0 when the customer install it all configure param?ters disappears.

The customer used .PCF

Do you have and answer about this, it is and Bug ?

Thanks

Herv?

2 REPLIES
Silver

Re: Preconfigure Cisco VPN Client 5.0.00.0340 do not work

Following method may help you. Place all VPN client 5 install files in a folder, then added PCF files into that folder at the same level as vpnclient_setup.exe. Dont do anything with .ini files. I think when the vpnclient_setup will run, it will pick up the pcfs and install them.

Bronze

Re: Preconfigure Cisco VPN Client 5.0.00.0340 do not work

From the Release notes for Cisco VPN Client 5.0.00.0340... it says the following:

Advisory:

The Cisco VPN Client for Windows Vista does NOT support the following:

* System upgraded from Windows XP to Vista (clean OS installation required).

* Start Before Logon

* SmartCard Authentication

* Integrated Firewall

...etc

____

Based on this, you should have this installed on a fresh machine note upgrading it from a machine that used to run an older version of vpn client (I think it has something to do with registry keys)

Plz rate if this helps!

Regards,

372
Views
0
Helpful
2
Replies
CreatePlease to create content