Hi, I am not able to insert the following command to enable prioriry queue.
Firewall(config)# priority-queue ?
configure mode commands/options:
Current available interface(s):
Secondly, I have a site to site VPN on ASA 5510 and PIX. The ASA is connected to cisco 2960 switches. I am running the Voice phones that are connected to the switches. I have given the cos value 6 on the switches. how can i anable the prioroty of voice over the site to site VPN and on the firewall?
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...