I have router 1720 and IOS ip plus ipsec 12.1.18 and i need configurate this router with cisco vpn client 3.x. I don't know where i can configurate username which i need put to client. I think it is name of group in configuration of router but i can't use command
crypto isakmp client configuration group xxx
On my cisco 1720 is command crypto isakmp client configuration address-pool ........
The minimum IOS that is required to configure the router to accept connections from 3.x client is 12.2(8)T. You can download the IOS software from the software center and make sure that you have sufficient Flash and Mem before doing the upgrade.
I don't understand the line of IOS. I downloaded 12.2.13a and this IOS can't command 'group' too. I though it's the newer version of 12.2.8.T. I have on the client side only 36MB RAM and 8BM Flash. 12.2.8.T need 48MB RAM. 12.2.13 only 32 MB. Can I use another version of IOS for my situation?
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...