I have a unit of VPN3060. Fresh from the box, I can access it via console and put some configuration. No changes whatsoever on the access method, i.e disabling console access.
However, when I tried to access it via console again, it doesn't work. Access to other devices (router & switches) using the same console cable/com port works fine. The com port configuration is 9600-8-N-1 (standard for cisco router/switch/pix/vpn).
So far, I did not see any specific troubleshooting tips on this.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...