Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

problem in SDM with DS3 card

Hi,

I have 3825 router, and a subrate T3/E3 card. I installed SDM version 2.3.1 on the router. The router sees the T3/E3 card and assigns int s1/0 to it.

But when I load SDM, it could not recognize this card (int s1/0). Any body know how to configure SDM for it to recognize the T3/E3 card? Thank so lot.

Tung.

2 REPLIES
Silver

Re: problem in SDM with DS3 card

I think you have to run the card type command and try it out . Cisco Router and Security Device Manager (Cisco SDM, and hereinafter called SDM) is a web-based configuration tool that allows you to configure LAN and WAN interfaces, routing, Network Admission Control (NAC), Network Address Translation (NAT), firewalls, Intrusion Prevention System (IPS), Virtual Private Networks (VPNs), and other features on the router. SDM 2.1 and later versions can be installed on a PC, or on the router. Earlier versions of SDM cannot be installed on PCs, and can be installed on the router. If you have a router listed in the "Hardware Supported" section, SDM is either preinstalled in router memory, or is shipped on a CD with the router.

Cisco Employee

Re: problem in SDM with DS3 card

Hi,

Please attach the output of "show runn", "show ver" and "show diag" to help.

Ravi

119
Views
0
Helpful
2
Replies