Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Problem in VRRP configuration between two VPN Concentrator

Hi,

I've a problem as specified in Title.

It seems that the configuration is correct, but when I shutdown the master I can't ping to the virtual address..the standby is on and I can manage it....but the virtual address is not responding.

Any ideas?

Thank you.

Best regards.

Massimiliano.

1 REPLY
Cisco Employee

Re: Problem in VRRP configuration between two VPN Concentrator

Hi,

I think this is expected behavior.

Note: VRRP enables redundancy for tunnel connections only. Therefore, if a VRRP failover occurs, the backup only listens to tunnel protocols and traffic. Pinging the VPN Concentrator does not work. Participating VPN Concentrators must have identical configurations. The virtual addresses configured for VRRP must match those configured on the interface addresses of the Master.

Please refer the below URL for details:

http://www.cisco.com/en/US/products/hw/vpndevc/ps2284/products_tech_note09186a0080094490.shtml

Regards,

Arul

** Please rate all helpful posts **

182
Views
3
Helpful
1
Replies
CreatePlease login to create content