Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

Problem inVPN ra PIX(7x)to VPN client cisco

I have upgrade my 515 pix from 6.3(4) to 7.0(4). I have configured frist,one l2l VPN with remote 501 pix(6.3),and then work well,after i have configured one vpn for remote access from host behind nat but doesen't work!

Can we help me?

TY

Fabio

2 REPLIES
Silver

Re: Problem inVPN ra PIX(7x)to VPN client cisco

In this sample configuration, a remote PIX receives an IP address through Dynamic Host Configuration Protocol (DHCP) and connects to a central PIX. This configuration enables the central PIX to accept dynamic IPSec connections. The remote PIX uses network address translation (NAT) to "join" the privately addressed devices behind it to the privately addressed network behind the central PIX. The remote PIX can initiate connections to the central PIX (it knows the end-point), but the central PIX cannot initiate connections to the remote PIX (it does not know the endpoint).

http://www.cisco.com/en/US/products/sw/secursw/ps2308/products_configuration_example09186a0080094680.shtml

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/prod_configuration_examples_list.html

New Member

Re: Problem inVPN ra PIX(7x)to VPN client cisco

ty but the problem is with cisco pix version 7.X, your configuration example the PIXs have 6.x software!

ty for your help

199
Views
0
Helpful
2
Replies
CreatePlease to create content