Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Problem with client remote connection

I have a VPN set up in office.

Clients are able to connect from remote site (behind another PIX), but unable to ping or connect to any devices.

It was noticed that in the client's statistics, the number of Encrypted Packets is increasing,but the Decrypted Packets remained at 0.

After i configure NAT from public to private IP address, the problem was resolved.

like to seek advise on what to do, to allow clients to connected to Office's devices without configuring NAT on other remotes' PIX?

2 REPLIES
Community Member

Re: Problem with client remote connection

It is noted that the client is not receiving any VPN packets.

Re: Problem with client remote connection

hi

I suspect in your pix the return traffic pointing towards your client vpn pool mite be getting natted.

access-list 101 permit ip 192.168.10.0 255.255.255.0 172.16.1.0 255.255.255.0

!

nat (inside) 0 access-list 101

in this where 172.16.1.0/24 is assumed as the vpn pool assigned to the remote users & 192.168.10.0/24 you local lan block.

regds

199
Views
0
Helpful
2
Replies
CreatePlease to create content