I just received the update in regards to 3.1(2)S26 update for the IDS.
The update for the IDS sensor was smooth and installed with no problems. I then proceeded to update the CSPM signature file on the NT Server. Everything seemed fine with the install and gave no notification of any errors. I then went into the Signatures menu to enable the new signatures however they were not listed! I checked the pulldown that enables the filtering for only signatures by version, the 3.1(2)S26 option was available yet no new signatures are present.
I then went into the new sig.data file with wordpad and noticed something odd. The new signature numbers are listed in the appropriate category however the signature entries for all the new signatures were not even present in the file
Here is the code which links the individual signatures to the proper version :
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...