11-23-2010 12:02 PM - edited 03-09-2019 11:17 PM
Hi everyone.
I have a problem with a IDS module.
This is the problem, the ids module is in the slot 5, in status "power down" when I excute the command " power enable mod 5" his status change to "other"
Information:
cisco 6509
ios: 12.2(18)SXF1
IDS module information:
HW:5.0
Thnks.
Solved! Go to Solution.
11-24-2010 07:08 AM
Jorge;
First, you may wish to move this thread to the Security>Intrusion Prevention Systems/IDS community which handles questions on Cisco's IPS appliances and modules.
Second, the issue may be hadware related. The first test would be to remove the module from the chassis for ~20 minutes and then firmly reseat it in the chassis. If this does not correct the issue, it would be best to open a service request with TAC so additional testing can be performed.
Scott
11-24-2010 07:08 AM
Jorge;
First, you may wish to move this thread to the Security>Intrusion Prevention Systems/IDS community which handles questions on Cisco's IPS appliances and modules.
Second, the issue may be hadware related. The first test would be to remove the module from the chassis for ~20 minutes and then firmly reseat it in the chassis. If this does not correct the issue, it would be best to open a service request with TAC so additional testing can be performed.
Scott
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: