Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Problem with IDS in 6509

Hi everyone.

I have a problem with a IDS module.

This is the problem,  the ids module is in the slot 5, in status "power down" when I excute the command " power enable mod 5" his status change to "other"

Information:

cisco 6509

ios: 12.2(18)SXF1

IDS module information:

HW:5.0

WS-SVC-IDS2-BUN-K9

Thnks.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Problem with IDS in 6509

Jorge;

  First, you may wish to move this thread to the Security>Intrusion Prevention Systems/IDS community which handles questions on Cisco's IPS appliances and modules.

  Second, the issue may be hadware related.  The first test would be to remove the module from the chassis for ~20 minutes and then firmly reseat it in the chassis.  If this does not correct the issue, it would be best to open a service request with TAC so additional testing can be performed.

Scott

1 REPLY
Cisco Employee

Re: Problem with IDS in 6509

Jorge;

  First, you may wish to move this thread to the Security>Intrusion Prevention Systems/IDS community which handles questions on Cisco's IPS appliances and modules.

  Second, the issue may be hadware related.  The first test would be to remove the module from the chassis for ~20 minutes and then firmly reseat it in the chassis.  If this does not correct the issue, it would be best to open a service request with TAC so additional testing can be performed.

Scott

213
Views
0
Helpful
1
Replies
CreatePlease to create content