10-29-2006 01:10 AM - edited 03-09-2019 04:42 PM
Hi,
I have a PowerPC (PPC) Mac Mini with which I'm trying to contact a VPN3000 private network.
Under Windows XP, the connection works fine, I get an IP address, a virtual adapter appears under "ipconfig" and I can contact the host I need to get to.
Under Mac OS 10.4.8 (PPC) with VPNclient 4.9.0050, it seems to connect, but I can't contact the client. It appears that no routes are setup, nor a virtual adapter. Here's the output from "vpnclient" - note the lack of routes..
Can somebody help!? TIA. Tom
walden-lodge:~ tom$ /usr/local/bin/vpnclient stat
Cisco Systems VPN Client Version 4.9.00 (0050)
Copyright (C) 1998-2005 Cisco Systems, Inc. All Rights Reserved.
Client Type(s): Mac OS X
Running on: Darwin 8.8.0 Darwin Kernel Version 8.8.0: Fri Sep 8 17:18:57 PDT 2006; root:xnu-792.12.6.obj~1/RELEASE_PPC Power Macintosh
Config file directory: /etc/opt/cisco-vpnclient
VPN tunnel information.
Connection Entry: westbury
Client address: 192.168.101.11
Server address: 85.41.89.219
Encryption: 56-bit DES
Authentication: HMAC-MD5
IP Compression: None
NAT passthrough is active on port UDP 4500
Local LAN Access is disabled
VPN traffic summary.
Time connected: 0 day(s), 00:00.16
Bytes in: 0
Bytes out: 431
Packets encrypted: 3
Packets decrypted: 0
Packets bypassed: 13
Packets discarded: 0
Configured routes.
Secured Network Destination Netmask
0.0.0.0 0.0.0.0
walden-lodge:~ tom$ ping 192.168.1.5
PING 192.168.1.5 (192.168.1.5): 56 data bytes
ping: sendto: No route to host
ping: sendto: Host is down
^C
--- 192.168.1.5 ping statistics ---
7 packets transmitted, 0 packets received, 100% packet loss
02-02-2007 12:11 AM
Hi,
I have the same problem as you.
If I use Window XP under Parallels on a Mac Intel machine, I can connect and browse the network correctly, however under Mac OS X, the route seem inconsistent.
Did you find a solution to this problem?
Anyone has a hint on this issue?
Best Regards,
Camille
02-04-2007 08:55 AM
I am trying to using VPN client 4.9 on a G5 (dual processor) OSX 10.4.8. I read and reread the instructions. I go to the command line and copy the INI and profiles into the installer.
When I try to open the VPN client I receive "Error 51: Unable to communicate with the VPN subsystem". The only information I can find on Error 51 is that it is a windows error. Some help. I can't even uninstall the software.
Is any one else having this problem?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: