Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

problem with nat + vpn

Hi

I have a problem with my vpn. I have two client that have the same subnet. I make a draw to explain that because my english is bad :

http://kenshin-est.chez.tiscali.fr

I proceed like that : i define "virtual" ip (40.0.1.0, 20.0.1.0, 30.0.1.0) to separe the same subnet. I create the vpn between the "virtual" address. So i must nat the real address. I have a problem with that. I use the command static (static (inside,outside) 20.0.1.0 10.0.10) so the address is well change. But i have a new problem : the address is nat into 20.0.1.0 so i can't go to the web because there is no nat to change my private ip into a public ip.

To sum up i dont know how i create "different" nat if i go to the vpn i will nat into 20.0.1.0 and if i go the web i'll nat into my public ip. I don't know if it possible.

Thx u very much.

regards,

Kenshin

2 REPLIES
Bronze

Re: problem with nat + vpn

Hi Kenshin ,

As far as my knowledge goes, this cannot be done.

New Member

Re: problem with nat + vpn

Thx u anyway :)

84
Views
0
Helpful
2
Replies
CreatePlease login to create content