Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Problems in reverse route injection

We have a setup where the hub router is connected to different spoke routers.We are running eigrp, the back connectivity is through vpn tunnels. When the primary link comes up after a failure then the reverse routes are not getting deleted.we have to manually clear the sa .tried using reverse router remote peer ip address in the crypto map without sucess.I am attaching the show techsupport and debug outputs of the hub router and a sample spoke. Pl suggest

1 REPLY

Re: Problems in reverse route injection

Try to enable keepalives with same values on ALL sites:

crypto isakmp keepalive 20 3

Regards

Farrukh

219
Views
0
Helpful
1
Replies