Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Problems with the Transfer vlan between MSFC and FWSM

I wanted to use a VLAN with an IP-Adress at the MSFC2 as a transfer VLAN for the FWSM.

The MSFC should route to the outside. The FWSM is in a Multi-Context, routing Mode and

there should only be one Transfer-vlan.

The Cat6500 has CatOs and the MSFC IOS.

So i tried to set up this vlan as a firewall-vlan on the Switch Cat6500 "set vlan xxx

firewall-vlan y", but this is not possible. Does anyone know whats the Problem an how

i can solve it ?

1 REPLY
New Member

Re: Problems with the Transfer vlan between MSFC and FWSM

Following is a sample configuration and you need to create SVI on the MSFC2 to be able to route the traffic via MSFC.

Good Luck !

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/mod_icn/fwsm/fwsm_2_3/fwsm_cfg/examples.htm#wp10526

105
Views
0
Helpful
1
Replies
CreatePlease to create content