Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Problems with VPN client 3.0

I log on to an AS/400 using Cisco VPN client software v 3.0 with a dial-up connections. The tunnel is closed in a PIX 515 fw over an HDSL line.

After 10 minute (approximately) inactivity the next AS/400 command

will give me a connection closed in the TN5250 window's status message.

Looking at the AS/400 job log the command has been logged, but my connection

is now "dead", and any PC applications using Client Access API's will fail

to reach the AS/400 as well.

Has anyone experienced the same problem?

1 REPLY
Silver

Re: Problems with VPN client 3.0

I think you need some keepalives going through the tunnel. What version of PIX code are you using?

91
Views
0
Helpful
1
Replies
CreatePlease login to create content