Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Proper upgrade order for R to UR upgrade

I was wondering if anyone has a link to the proper upgrade order for a 515e R to 515e UR. I have the licenses and memory, but have not found a clear order for the upgrade. But this is my guess.

1 - Install 128 megs of ram

2 - Add new activation key

3 - Install VAC+ card and 4 fe card

Is this correct? Thanks,

Adam

2 REPLIES

Re: Proper upgrade order for R to UR upgrade

Hi .. yes that is correct .. from the below link perform steps 4, 6 (select no),7 and 8. Once the PIX reboots with the new activation key you can install the VAC+ or you could install the modules before renewing the license if you like too. If your current license already has at least DES enabled then the module should be recognised otherwise it will once the new license is upgraded.

I hope it helps ... please rate if it does !!!

http://www.cisco.com/en/US/products/sw/secursw/ps2120/products_configuration_guide_chapter09186a008008c136.html#4703

New Member

Re: Proper upgrade order for R to UR upgrade

Thanks alot, just what I needed.

91
Views
5
Helpful
2
Replies