Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

QoS in the IOS?

I'm trying to figure out which of my devices support QoS and so far it seems like none of them do.

I have a Cisco Catalyst 2924XL with this IOS image c2900xl-c3h2s-mz.120-5.WC8.bin

I have a Cisco 7206 router with this IOS c7200-jk9o3s-mz.122-10.bin

and finally I have a PIX firewall with IOS version 6.3(1) image i28F640J5 (i think)

I was hoping my switch would support QoS since that is where we need it, but if I have to I can temporarely use the PIX or 7206.

but none of these devices have QoS as a show option, only the queing

2924#sh q?

queue queueing

7206#sh q?

qdm qllc queue queueing

The PIX has no options under show for anything starting with the letter q.

Anybody know if I'm looking in the wrong spots or if these devices don't have QoS in the IOS?

also if none of these devices have QoS, is there another cisco command I can use to limit the bandwidth out of a port in the switch?

Thanks

Chris S.

IT Engineer

www.sightspeed.com

3 REPLIES
Cisco Employee

Re: QoS in the IOS?

Only PIX doesnot support QOS as of yet. I belive 7206 and 2924 will/should support QOS.

Thanks

Nadeem

New Member

Re: QoS in the IOS?

Nadeem is correct. Both the 7206 and 2924 supports QoS, wish the PIX did.

New Member

Re: QoS in the IOS?

where do I find the commands?

cause show QoS doesn't work, and that's what it says in the 7200 series notes.

I looked around in the router and didn't find the commands.

I was also looking for rate limit.

90
Views
0
Helpful
3
Replies
CreatePlease to create content