Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Query on pix 525 version 6.2(2)

Hi,

I have upgraded the PIX 525 from version 5.3(2) to version 6.2(2). The upgrade was successfull but I have noticed that the command

isakmp identity hostname was no longer in the config in 6.2(2). Correct me if I am wrong, I do not think the command is needed as we are not doing any ipsec tunnelling. Another thing is, the cryptochecksum is all zeroes after the upgrade too. I have to do a wr m for the cryptochecsum to have a value. Is it because of the change I made to the hostname after the upgrade?

Thanks.

1 REPLY
New Member

Re: Query on pix 525 version 6.2(2)

If you are not using IPSec, you don't have to worry about the isakmp identity command. In case you are interested; if you don't find the command, IP address is the default identity method for ISAKMP.

91
Views
0
Helpful
1
Replies