Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Question about CSIDS-313-engrel2.tar.Z

Two Questions....

In the readme file at step 5 the command is tar xvf CSIDS-313-eng.tar.

Is the command typed wrong because the file name does not match the file name in the previous steps.

When I do the command tar xvf CSIDS-323-engrel2.tar.Z I receive a directory checksum error. Why am I getting a checksum error?

4 REPLIES
New Member

Re: Question about CSIDS-313-engrel2.tar.Z

You missed the uncompress step before.

gzip -d CSIDS-323-engrel2.tar.Z (gives you CSIDS-323-engrel2.tar)

and after that

tar -xvf CSIDS-323-engrel2.tar

Cisco Employee

Re: Question about CSIDS-313-engrel2.tar.Z

The readme is incorrect for steps 4 and 5. The should read as follows:

4) uncompress CSIDS-313-engrel2.tar.Z

5) tar xvf CSIDS-313-engrel2.tar

The reason your tar received and error was because you need to uncompressed the file 1st.

I will talk to the owner of the file to get the README corrected.

New Member

Re: Question about CSIDS-313-engrel2.tar.Z

Is 3.1.3 still in early release? If so, any schedule yet for general release?

Cisco Employee

Re: Question about CSIDS-313-engrel2.tar.Z

Currently this fix is only available as an engineering release. We have been discussing when it will be sent out as a general release but nothing has been decided as of yet.

109
Views
0
Helpful
4
Replies
CreatePlease to create content