Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

question about upgrading software version

I'm about to upgrade the sw on our pix from 6.0(1) to 6.11, this being the first time i've done this i'm not sure if a reboot of the pix is necessary, the docs just say 'copy tftp flash' is all i need to do. Do I need to power cycle?

Single PIX 525.

Thanks.

1 REPLY
New Member

Re: question about upgrading software version

Usually you load IOS in monitor mode right? Wouldn't that be considered a reboot? Maybe not on a 525 though. Once the flash is re-written, usually a wr mem follows, as well as a reload. I don't believe an actual power cycle is necessary.

104
Views
0
Helpful
1
Replies
CreatePlease to create content