Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

"Death by retransmission P2"

After some initial troubleshooting it appears that my remote VPN device is "too busy" to service my phase 2 "rekeys" from my local VPN device. I see the following in my debug output ...

"Death by retransmission P2"

Does anybody know if I can configure my local Cisco VPN Device (IOS) to retransmit phase 2 "rekey" at something other than the default values. I need to know this ASAP so any help would be greatly appreciated.

1 REPLY
Cisco Employee

Re: "Death by retransmission P2"

Eric,

Best bet is to open a TAC case on this as the cause can only be determined by looking at the logs in more detail.

Aamir

407
Views
0
Helpful
1
Replies
CreatePlease to create content