cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
767
Views
0
Helpful
1
Replies

"Death by retransmission P2"

ericj
Level 1
Level 1

After some initial troubleshooting it appears that my remote VPN device is "too busy" to service my phase 2 "rekeys" from my local VPN device. I see the following in my debug output ...

"Death by retransmission P2"

Does anybody know if I can configure my local Cisco VPN Device (IOS) to retransmit phase 2 "rekey" at something other than the default values. I need to know this ASAP so any help would be greatly appreciated.

1 Reply 1

awaheed
Cisco Employee
Cisco Employee

Eric,

Best bet is to open a TAC case on this as the cause can only be determined by looking at the logs in more detail.

Aamir

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: