Re: "ip address dhcp retry 48 setroute" in PIX7.0?
In PIX 7.0/PIX7.2, the command you're looking for is no longer available.
Extract from Cisco PIX7.2 Command doc:
To use DHCP to obtain an IP address for an interface, use the 'ip address dhcp' command in interface configuration mode. To disable the DHCP client for this interface, use the 'no' form of this command.
Available command option:
ip address dhcp [setroute]
no ip address dhcp
However, this command is clearly available in PIX6.3(5):
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...