Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

"ip inspect tcp max-incomplete host" command parameters

Hi all,

I have a 7200 router with IOS version 12.3(3)B1 and I am able to configure a limit of 500 for the "ip inspect tcp max-incomplete host" command:

ip inspect tcp max-incomplete host 500 block-time 0

I am migrating to a 7600 with version 12.2(18)SXF but I am not able to configure the limit of 500 as in the 7200. I checked the documentation and the limit is 250, is there a way to increase this value to 500 for the 7600?

Regards.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: "ip inspect tcp max-incomplete host" command parameters

Unfortunately, there is no way to increase this value to 500. I checked both 12.2(18)SXF and 12.2(33)SRB1 and they both have a limit of 250.

Regards,

Arul

** Please rate all helpful posts **

1 REPLY
Cisco Employee

Re: "ip inspect tcp max-incomplete host" command parameters

Unfortunately, there is no way to increase this value to 500. I checked both 12.2(18)SXF and 12.2(33)SRB1 and they both have a limit of 250.

Regards,

Arul

** Please rate all helpful posts **

145
Views
0
Helpful
1
Replies
CreatePlease to create content