Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

"vpn 3002 hardware client" and other vpn device

when I make a session between vpn 3002 hardware client at remote site and concentrator 3000 series or PIX or Router at central site. "Server A" is located at remote site and "Server B" is located at Central site. "Server A" and "Server B" communicate with IPSEC Tunnel. I know that "Server A"(at remote site) can initiate make a session to "Server B"(central site). Is it possible that "Server B"(central site) initiate make a session to "Server A"(remote site) ?

1 ACCEPTED SOLUTION

Accepted Solutions
Bronze

Re: "vpn 3002 hardware client" and other vpn device

Hi sbjeong,

If you are running NEM mode on the 3002, then either servers can initiate the traffic assuming that the IPSec tunnel between your 3002 and the VPN server (PIX, IOS, VPN3K ) is established

Jazib

2 REPLIES
Bronze

Re: "vpn 3002 hardware client" and other vpn device

Hi sbjeong,

If you are running NEM mode on the 3002, then either servers can initiate the traffic assuming that the IPSec tunnel between your 3002 and the VPN server (PIX, IOS, VPN3K ) is established

Jazib

New Member

Re: "vpn 3002 hardware client" and other vpn device

Have you tryed adding a route statement on server b pointing to the vpn and on the vpn point back to the public interface. Can you initiate a ping from your VPN to the Remote sites VPN? It is the same issue. Try that and see if that helps.

86
Views
0
Helpful
2
Replies
CreatePlease to create content