08-21-2002 09:22 AM - edited 03-09-2019 12:01 AM
I have a sensor that was previously configured as token-ring. now the token ring card has been removed and an ethernet card installed. How do i reconfigure solaris x86 to recognize the new card. The touch /reconfigure incantation does not appear to work.
08-21-2002 11:43 PM
you could try clearing the bios settings. touch reconfigure, reboot and interrupt the boot sequence, find an option to clear all settings, then reboot again.
08-22-2002 07:11 AM
Your best bet is to re-image the sensor using the 3.0 Recovery CD (or later). The new image includes a script to identify network interfaces and load the appropriate drivers. Assuming you are using a supported ethernet card, this should fix your problem. Use of non-approved network interfaces on the Cisco IDS sensor appliance is unsupported.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide