Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

reconfiguring sensor network hardware

I have a sensor that was previously configured as token-ring. now the token ring card has been removed and an ethernet card installed. How do i reconfigure solaris x86 to recognize the new card. The touch /reconfigure incantation does not appear to work.

2 REPLIES
New Member

Re: reconfiguring sensor network hardware

you could try clearing the bios settings. touch reconfigure, reboot and interrupt the boot sequence, find an option to clear all settings, then reboot again.

New Member

Re: reconfiguring sensor network hardware

Your best bet is to re-image the sensor using the 3.0 Recovery CD (or later). The new image includes a script to identify network interfaces and load the appropriate drivers. Assuming you are using a supported ethernet card, this should fix your problem. Use of non-approved network interfaces on the Cisco IDS sensor appliance is unsupported.

189
Views
0
Helpful
2
Replies
CreatePlease to create content