i couldn't find any recovery procedure in the documentation, that tells me, how to get a replaced (fresh) FWSM to work as quick as possible.
As far as i can see, we have to create all that vlan1 stuff, create interfaces and so on, to get the previously saved startup-config back to the replaced FWSM via network. Is there any way to shorten that procedure, e.g. to leave a FWSM config copy on the switch and transfer it internally to the startup-config?
So i'm actually looking for the shortest way possible, to get a fabric new FWSM to work after the old damaged one got replaced.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...