Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Regarding VPN

Hi Guys,

I have Configured a site-to-site VPN tunnel between pix and VPN 3015

here the problem is the PIx at the remote end doesn't have the public ip .I have terminated the Tunnel at the DSL modem

the tunnel was established and the Data traffic also happens but after 30min or

i hour any one of the IPsec tunnel will not work

i have defined 5 ACl's in there 3 is always accessable (3 Networks)

2 is giving problem

if reboot the pix then every thing will work for 30-45 min then the same problem.

even i have reduced the IPsec lifetime

to 3600 sec

but nothing happens

at last i have decided to Configure the pix and Concentrator as given in the Attached Document

My question is if configured like that does it affcet my exsisting VPn users? (Remote VPN)

Please advice

Thanks

krishna.

1 REPLY
Silver

Re: Regarding VPN

Console into the PIX. From a cleared configuration, use the interactive prompts to enable Advanced Security Device Manager GUI (ASDM) for the management of the PIX from the workstation.For more info refer the following URL

http://www.cisco.com/en/US/products/ps6120/products_configuration_example09186a008045a2d2.shtml#pixfw

103
Views
0
Helpful
1
Replies
CreatePlease to create content