Register Remote Agent with ACS

[nmoore1978]

I just recently installed the eval version of ACS 4.1(1) Build 23. I also downloaded the same version of the remote agent and loaded that on a domain controller so I can authenticate against my AD. However, when following the directions to configure the remote agent on ACS I run into a problem.

The online instructions tell me to click on Network Configuration and click on "Add Entry" in the Remote Agents table. The problem is that I don't see a Remote Agents table within my Network Configuration page. What am I doing wrong?

Thanks in advance,

Nick

[Jagdeep Gambhir]

Nick,

It should be under NDG.

ACS--->Network configuration---->NDG--->RA

Regards,

~JG

[nmoore1978]

JG,

I don't have the option for RA within NDG. I have attached screen shots to show what I'm seeing. I have also enabled "Distributed System Settings" in the Interface Configuration section.

Thanks for taking the time to help.

Nick

[Jagdeep Gambhir · Accepted solution]

Nick,

You have acs running on windows server , so there is not need to have remote agent installed.

Remote agent is needed with acs appliance and not with acs windows.

Regards,

~JG

Please rate if helps